Contact Us

TEL: +86-574-63297063
E-mail: candy@zhongdingpcsheet.com

Address: NO.42, Binhai 5th road, Hangzhou Bay New Zone, Ningbo, China.

Home > News > Content
Solid PC Endurance Plate Installation Method
Apr 18, 2016

Installation overview

A. transport PC board surface on which it should be careful not to wipe wounds, damaged edge. Use scissors or drilling tool with the desired size after cut, then along each side remove the protective film after the installation of 50mm, remaining until the installation is completed, and then remove. Is also requires attention, all open for on the edge should be appropriate to the film in order to avoid water, dust or other intrusion.

B. in a later chapter, the minimum bending radius of hollow Board is 175 times times its thickness can only be cold, not bending.

C. solid slab minimum bending radius is 150 times times the thickness 6mm thickness can be cold and hot forming, 8mm thickness bending is required.